průtokoměr IE 250 A
Pro více informací, prosím, kontaktujte prodejce:
- Ing. Martin Vondráček
- +420 778 759 907
- martin.vondracek@labtech.eu
Technická specifikace
| Full Scale Flow Range | 100 - 250 slm (N2 equivalent) |
| Maximum Inlet Pressure | 150 psig (cannot exceed pressure differential requirement across MFC) |
| Normal Operating Pressure Differential | 30 to 55 psid (dependent on fitting type) (with atmospheric pressure at the MFC outlet) |
| Burst Pressure | 1500 psig |
| Control Range | 2% to 100% of Full Scale (range on mech.) |
| Typical Accuracy | ±1% of setpoint for >20% to 100% Full Scale ± 0.25% of Full Scale for 5% to 20% Full Scale |
| Repeatability | ± 0.5% of Reading |
| Resolution | 0.1% of Reading |
| Temperature Coefficients | |
| Zero | <0.05% of Full Scale/°C |
| Span | <0.08% of Rdg./°C |
| Inlet Pressure Coefficient | <0.03% of Reading/psi or less |
| Typical Controller Settling Time | 1 to 2 seconds typical above 10% Full Scale @ 50 psi |
| Warm-up Time | one (1) hour |
| Operating Temperature Range | 10°C to 50°C (Ambient) |
| Storage Humidity | 0 to 95% Relative Humidity, non-condensing |
| Storage Temperature | -20° to 65°C (-4° to 149° F) |
| Fittings | Compatible with: 8 VCO® male, 1/2 inch NPT female, 1/2 inch Compression, 8 VCR® male |
| Leak Integrity | |
| External | <1 x 10-9 (scc/sec He) |
| Through closed valve | <1.0% Full Scale at 40 psia to vac (<500 mTorr) (To assure no flow-through, a separate positive shut-off valve is required.) |
| Wetted Materials | 316 S.S., 17-1 S.S., Elgiloy, 430FR (Standard) |
| Seal Options | Viton®, Buna, Neoprene, EPDM |
| Surface Finish | 16 µinch average Ra |
| Weight | Less than 4.5 lbs. (2.05 kg) |
| Enclosure Rating | IP66 |
| Compliance | CE Compliant to EMC Directive 2004/108/EC |
| Input Power Required | +15 to +24 VDC @ (<4 watts) |
| Flow Input/Output Signal | |
| Voltage | (0 to 5 VDC) 15-pin Type "D" male |
| Current | (4 to 20 mA) 15-pin Type "D" male |
Máte dotaz?
Pole označená (*) musí být vyplněna
LABTECH s.r.o © 2011, Polní 23/340, CZ 639 00 Brno, Tel: +420 511 110 711, Fax: +420 543 210 115, info@labtech.eu